At this point, we started trying to flip that white connector up Which turned out to be a mistake, we snapped the fragile little pieces a bit

Nothing major The black connector where the ribbon goes in does flip up, and will need to be up when you put the drive back in From here, it's boring until we figure out to take the drive out then deal with the ribbon Skip to 4:00 That tape was stuck on there well, but once you get an edge, it comes up easily I only disconnected the longer wiring harness

The shorter one seemed so fragile, I worked around it, but be careful pulling the tape off those wiresStill debating on the fragile small wiring harness, but ultimately we left it in Be careful removing that ribbon from the SSHD It's got wiring in it and shouldn't be bent